Cold Air Return Duct Frame

Product is knocked down for shipping and must be.

Cold air return duct frame.

21 75w x 31 75h 4 4 out of 5 stars 256 60 99 60. It has a 1 2 90 degree bend on all four sides. Can be easily cut to size. First building codes in many areas require that the cold air return line gets external insulation and therefore you will need to leave a gap for the insulation around the duct return line.

This product is proudly made in the usa using galvanized steel for durability and rust prevention. It can be installed directly onto the wall studs before the drywall is installed to save time and ensure correct placement. When cavity spaces are used as return air pathways or supply air ducts a few issues will arise. It provides the transition from the wall duct chase to a wall grille.

The master flow cold air frame is used in a heating and air conditioning system to provide the transition from the wall duct chase to a wall grille. A cavity space used as a return air pathway will pull pollutants into the building from unknown sources. Because cavity spaces are leaky building pressure imbalances across the building envelope will occur driving air infiltration into the building. Can accept any size collar up to 18 in.

The tabs provide an easy install. A furnace return system must collect all the air being put out by that system. Used as a central return vent box filter grill not included. 4001 mark iv parkway fort worth tx 76106 phone.

An insufficient return system or one too large will reduce the efficiency of the heating and increase energy bills. This product is proudly made in the usa using galvanized steel construction for durability and rust prevention. 20 x 30 steel return air filter grille for 1 filter removable face door hvac duct cover flat stamped face white outer dimensions. If the furnace is putting out 1 000 cubic feet per minute of air flow the return system must collect 1 000 cubic feet and take it back to the unit.

If the supply ducts are high or in the ceiling then the return air ducts or grills should be low on. It is assembled with 1 8 zinc coated rivets. This pulls the air across your body. This cold air frame can either attached to the studs with nails or screws.

If the supply ducts are in the floor then the return air should be located up high. This product is installed before the drywall goes in. The return air vent openings need to be on the opposite side of the room so the conditioned air is pulled across the room. Wall grille not included.

Installs before the drywall is installed.